How to use polycarboxylate superplasticizer for different kinds of concrete?

Under the spread of the new crown epidemic, after Americans experienced life and death, they set off the largest "resignation wave" in history, and the number of resignations broke the highest record since statistics began in 2000. Since April this year, more than 4 million people in the United States have voluntarily resigned each month. In August, the number of resignations exceeded 4.27 million, and in November, it rose to 4.4 million. The operation of society is linked. The large number of departures in the United States has led to a large shortage of labor; and the shortage of a large number of labor has directly led to the supply chain crisis in the United States; the supply chain crisis has directly affected prices and prices in the United States. The economy has a direct effect on people's lives.
The economic downturn will affect the market demand for pce powder.

Prestressed or precast concrete

Adding polycarboxylate superplasticizer can make the compressive strength of precast concrete reach 40MPa grade at 8h to 18h; the precast concrete mixed with polycarboxylate superplasticizer can get higher early strength under the condition of lower curing temperature and shorter curing time, thus reducing the energy consumption of curing; in addition, it can save cement, reduce vibration energy consumption, reduce noise and improve the turnover rate of the mold.

Shrinkage compensating concrete

When preparing shrinkage compensating concrete, adding a certain amount of polycarboxylate superplasticizer can reduce the water-cement ratio, increase the early shrinkage of concrete and reduce the later shrinkage of concrete, thus saving expansive agent or expansive cement.

Ordinary aggregate concrete

For ordinary aggregate concrete, the addition of polycarboxylate superplasticizer can reduce the pumping pressure and pipe pressure by about 30%; for lightweight aggregate concrete, the addition of polycarboxylate superplasticizer can reduce the pumping pressure and pipe pressure by more than 10%; in addition, the addition of polycarboxylate superplasticizer can reduce the increase of pumping resistance with the increase of pumping speed.

Steel-fiber reinforced concrete

For steel fiber reinforced concrete, the addition of polycarboxylate superplasticizer can reduce the workability loss caused by the addition of steel fiber; of course, compared with the concrete without steel fiber, the amount of polycarboxylate superplasticizer mixed with steel fiber reinforced concrete should be appropriately increased.

Super high strength concrete

Polycarboxylate superplasticizer has good water-reducing dispersion and strengthening effect, so it can be used to prepare ultra-high strength concrete. The study found that the concrete mixed with polycarboxylate superplasticizer (20%), which accounts for 1% to 3% of the weight of the cementitious material, can make the 100-day-old strength as high as 150MPa.

High-alumina cement concrete

In order to ensure the performance of high-alumina cement concrete, the general water-cement ratio is not higher than 0.40 and the cement content is not lower than 400kg/m3, otherwise the strength of concrete, especially in the later stage, will decrease. The reason is that metastable calcium aluminate hydrate is transformed into steady tricalcium aluminate hydrate. If polycarboxylate superplasticizer is added to high alumina cement concrete, the fluidized concrete with good workability can be obtained under the condition of low water-cement ratio, and the later strength of concrete is not affected. That is to say, the 2d compressive strength of high alumina cement superplastic concrete mixed with polycarboxylate superplasticizer is lower than that of standard concrete, while the compressive strength of 180d age is basically the same as that of base concrete, because polycarboxylate superplasticizer has no obvious effect on the hydration rate of high alumina cement.

High-performance concrete with high content of active admixtures such as fly ash, slag, and silica fume

When preparing high-strength concrete with a large amount of fly ash instead of ordinary cement, adding polycarboxylate superplasticizer can improve workability, reduce mixing water consumption by about 20%, and further improve strength. The addition of polycarboxylate superplasticizer into concrete can increase the amount of cement-based substitute materials such as fly ash or slag and reduce the amount of cement without affecting the strength of concrete. therefore, it has outstanding environmental and economic benefits. Similarly, when silica fume is added to cement slurry or concrete, the amount of water needed to achieve the same workability increases with the increase of silica fume content. For this reason, under the condition of a certain amount of silica fume, polycarboxylate superplasticizer can be added to reduce the water consumption of mixing, and polycarboxylate superplasticizer can also be added to increase the amount of silica fume under the condition of a certain amount of water consumption.

Concrete Additives Supplier

TRUNNANO is a reliable foaming agents supplier with over 12-year experience in nano-building energy conservation and nanotechnology development.

If you are looking for high-quality polycarboxylate superplasticizer, please feel free to contact us and send an inquiry. (sales@cabr-concrete.com)

We accept payment via Credit Card, T/T, West Union, and Paypal. TRUNNANO will ship the goods to customers overseas through FedEx, DHL, by air, or by sea.

Against the backdrop of the conflict between Russia and Ukraine and Western sanctions imposed on Russia's natural gas exports, the price of natural gas and liquefied natural gas in the international market has soared, and the trend of returning to burning fuels such as oil and coal because natural gas cannot afford it has become increasingly prominent, Bloomberg reported recently. Data show that in early August, the price of natural gas on the international market was almost twice that of diesel, while the price of natural gas in Europe was almost three times that of high-sulfur fuel oil and propane. Industry insiders pointed out that many governments have recently announced that they will allow power stations to increase the use of oil and coal fuel because of concerns about the shortage of natural gas supply this winter. The International Energy Agency estimates that global oil demand will grow by 380000 barrels a day to 2.1 million barrels a day, based on the shift to oil in power stations and factories.

As the situation in the field of power generation varies from country to country, there are great differences in the extent to which countries use fuels such as oil and coal. Countries such as Pakistan and Bangladesh have large facilities that can switch between natural gas and fuel. In some countries, coal-fired and oil-fired power stations have been decommissioned for a long time, and the maintenance conditions of the equipment are different, so it is doubtful whether they can resume operation quickly.

Luoyang Tongrun Nano Technology is a trusted chemical manufacturer and supplier providing high-quality chemicals and Nanomaterials. If you are looking for the pce powder, please feel free to contact us and send an inquiry.

Inquiry us